/
Yealink

Yealink

Overrides

The below overrides are largely unnecessary at this time due to the advance tab and these overrides being in the GUI. However we will leave them below should you encounter them on an older domain.

XML Site/Department Directory

Yealink Department remote_phonebook.data.1.url="https://[[auth_user]]:[[auth_pass]]@horizon.connectware.cloud/api/phonebook/yealink/department/phonebook.xml" Yealink Site remote_phonebook.data.1.url="https://[[auth_user]]:[[auth_pass]]@horizon.connectware.cloud/api/phonebook/yealink/site/phonebook.xml"

Setting the VLAN ID

network.vlan.internet_port_enable="1" network.vlan.internet_port_vid="VLANID"

Web UI Access for HTTP

wui.http_enable="1" wui.https_enable="1" security.user_password="admin:nlv123"

Provisioning to ConnectWare

  1. Build the phone in ConnectWare.

  2. Determine the IP of the Phone and navigate to the IP via a browser.

  3. The default username/password is admin/admin

  4. Navigate to the “Settings” tab.

  5. Click on the "Upgrade" or “Auto Provision” section.

  6. In the URL field enter http://prov.secureuc.net/cfg/

    1. Contact support for the username and password, they are required.

  7. Also, confirm that the "Check New Config" is set to "power on” (If applicable)

  8. Hit "confirm" to save and once saved reboot the phone. W70B will have “Auto Provision” button on the bottom. Press this to start provisioning instead of rebooting. NOTE: Some phones only support TFTP. Connect them by removing the'/cfg' from the provisioning address of the Endpoints Module.

  9. Click “Auto Provision Now”