/
Yealink

Yealink

Provisioning to ConnectWare

  1. Build the phone in ConnectWare.

  2. Determine the IP of the Phone and navigate to the IP via a browser.

  3. The default username/password is admin/admin

  4. Navigate to the “Settings” tab.

  5. Click on the "Upgrade" or “Auto Provision” section.

  6. In the URL field enter http://prov.secureuc.net/cfg/

    1. Contact support for the username and password, they are required.

  7. Also, confirm that the "Check New Config" is set to "power on” (If applicable)

  8. Hit "confirm" to save and once saved reboot the phone. W70B will have “Auto Provision” button on the bottom. Press this to start provisioning instead of rebooting. NOTE: Some phones only support TFTP. Connect them by removing the'/cfg' from the provisioning address of the Endpoints Module.

  9. Click “Auto Provision Now”